Thyristor Controlled Water Cooled Anodizing Rectifier

Redarti Water Cooled Anodizing Rectifier

Microprocessor controlled thyristor rectifiers are fully automatic power sources used in industrial applications such as coating, painting, anodizing on metals and plastics to provide the required direct current. Controlled by microprocessor thyristor control provides high accuracy and precise regulation, resulting in high-quality results in the process. One of the most important features of thyristor controlled systems is Pulse - Base current control. In coatings realized with the Pulse - Base method, the coating reaches even the most remote corners no matter how much the parts have protrusions and indentations. The problem of insufficient coating seen in hard-to-reach areas is eliminated. The general coating distribution on the part is more proportional and saves time. Coating processes carried out using 600Hz and Pulse - Base method offer a quality far beyond traditional methods in every aspect.

The new AC Drive Unit RERARTI Coating rectifiers are equipped with a new AC power control unit. With this unit, rectifier failures are minimized while work efficiency and rectifier functions are increased. With the new AC drive unit, faults are prevented without causing damage. Thus, it can be used safely even under the most difficult conditions. The new Drive system has the ability to operate from both the remote control unit and the automation system at the same time. In addition to many ready-made features, it is open to additional features to be added over time. Timer With the timer in the operating program, operation for the desired period or indefinitely is provided. In time-limited operation, the rectifier operates at the desired values and automatically stops at the end of the period, warning the user. In continuous operation, the process continues until the user stops the device. Ampere-Hour and Automatic Dosing REDARTI Coating rectifiers have an Ampere-Hour calculation feature. This provides the most reliable data on the total operating time of the bath. The coating process can be operated according to the ampere-hour value instead of the time. Both ongoing coating processes and total operations have different counters on the operator panel. These counters can be used to automatically add chemicals to the bath. Especially in critical baths, chemical concentration control is extremely important. REDARTI rectifiers assist you in your chemical control. It also provides important data on the total operation and efficiency of the system. Selective Operation Program In many coating baths, a selective operation program is applied to remove unwanted metals from the bath. However, this process was previously done manually or with an external system. In the selective operation program offered in REDARTI coating rectifiers, this process is done automatically. After starting the process, the output voltage is increased to zero in the set period and returns to zero again. This process is repeated periodically or indefinitely. Thus, the laborious maintenance process of selective operation is easily performed. Easy to use REDARTI Standard Coating rectifiers have a very simple operation program. With the remote control unit, the operator can easily start the device without going to the rectifier. The system is fully compatible with all automation systems. It has both manual and automatic operation modes.