650 Ton (62 Kw) Plastic Injection Machine

The powerful mechanical system ensures precise mold adjustment, precise injection with linear guides, and superior quality performance.

Equipped with a High-Performance Servo System. The output power of the servo motor changes with the load without excessive energy loss. It reduces motor speed during pressure holding and energy consumption is extremely low. The motor does not operate during cooling, and energy consumption is zero. It increases injection accuracy while saving power, water, and reducing noise. A true revolution in hydraulic injection machines.

UN-M7, equipped with a highly responsive servo motor and internal gear pump system, reaches maximum output in just 0.05 seconds, significantly shortening the cycle compared to traditional hydraulic injection machines and increasing production efficiency.

The precision of UN-M7 is superimposed on the precision of the internal gear pump and creates a closed loop thanks to the high-precision pressure feedback device. Injection repeatability, significantly increases qualified mold parts that can reach 3, showing better injection stability and ratio than traditional hydraulic machines.

Optimized plate design, hinged support and single-piece casting of the moving plate, single-piece casting of the crosshead guide support, hinged seat, and back plate. It improves not only rigidity but also mold opening precision.

Ikaros Machine 650T Technical Specifications:

 

DESCRIPTION	DESCRIPTION	UNIT		VT-650V7
CLAMPING UNIT
Clamping Force	Clamping Force	ton		650
Max. daylight	Max. daylight	mm		1840
Clamping Stroke	Clamping Stroke	mm		920
Clearance Between Tie Bars	Clearance Between Tie Bars	mm		930х930
Min Mould Dimension	Min Mould Dimension	Mm		675x665
Mould Thickness Range	Mould Thickness Range	mm		370-920
Ejector Force	Ejector Force	ton		18.2
Ejector stroke	Ejector stroke	mm		280
No. of Ejector Pins	No. of Ejector Pins	unit		21
System Pressure	System Pressure	MPa		17.5
INJECTION UNIT
International Specification	International Specification			5000
Screw diameter	Screw diameter	mm	84	92	100
Theoretical Shot Volume	Theoretical Shot Volume	cm3	2328	2792	3299
Shot Weight (PS)	Shot Weight (PS)	g	2118	2541	3002
Length/Diameter Ratio	Length/Diameter Ratio	L/D	22	20	20
Injection Pressure	Injection Pressure	M Pa	218	181	154
Injection Rate	Injection Rate	cm3/s	579	695	821
Injection Stroke	Injection Stroke	mm		420
Screw Speed	Screw Speed	RPm		164
GENERAL INFORMATION
Major Motor	Major Motor	kW		32+50
No. of Heater Zones	No. of Heater Zones	unit		5+1
Heater Input Power	Heater Input Power	kW		38/47
Oil Tank Capacity	Oil Tank Capacity	L		1000
Net Weight	Net Weight	ton		29.5
Machine Dimension(L*W*H)	Machine Dimension(L*W*H)	M		10.5x2.28x2.75